A building siding is used as an outside covering such as for home exteriors meant to shed water and protect against the effects of harsh weather. It comes in many forms such as horizontal boards, vertical boards, shingles, or sheet materials. A building siding is either made up of wood, vinyl, metal, composite materials, or masonry.
Wood sidings are from naturally water-resistant woods that can be used on a wide variety of homes in any color palette desired. Installation and repair are relatively simple; however, it requires more maintenance every four to nine years. A plastic siding or a vinyl siding is usually produced in units twice as high as wood clapboards. It is widely used because of its low maintenance and low-cost appeals.
However, a siding does not provide additional insulation to the building unless an insulator has already been added to the product. An insulated siding is also used because it is custom fit with expanded polystyrene foam (EPS) merged in the back of the siding that closes the gap between the house and the siding. It is highly advisable to leave an air gap between the walls to allow water vapor to escape and maintain healthy indoor air.
Metal sidings are often associated with metro, industrial, and retro buildings. One good advantage of it is its dent-resistance which is excellent for locations having severe storms. However, some metal sidings presented problems with warping that creates opening for water thus introducing rust.
Masonry sidings are varied as brick and stone. It has excellent durability and only minimal maintenance is required. Various composite siding materials are also used such as asphalt, fiber, cement, and asbestos. These sidings are ideal for achieving a certain home exterior unsuitable to a local environment.
One of the most popular sidings introduced is the alcoa siding. Made by the Alcoa Home Exteriors Company, these sidings are known for its durability. Alcoa vinyl is highly resistant to extreme heat, high winds, and various weather condition changes. These sidings can provide an entire home with solid insulation, achieve a classic wooden exterior look, it is maintenance free, and cuts down external noise by 50%.
However, when slight damages on alcoa vinyl occur, you must be able to do the vinyl siding repair yourself. The things that you will need are new sections of sidings that match the damaged ones, special zipper to separate panels, polyurethane caulking, utility knife, square, pencil, and backsaw. You need to first unlock the panel next to the damaged one and pry the nails that hold the spoiled panels in place.
Mark cutting lines on each side and cut panels along the lines using the backsaw. Cut replacement pieces two inches longer than the previous sections to allow an inch longer to overlap on the end. However, it is essential that you cut only an inch longer if the damaged section ends at a joint. Finally, snap the top edge of the new sections in place and nail it with aluminum box nails.
Find out more about having sidings by visiting http://bestsidingsite.com/ and get all the FREE information about sidings now!
No comments:
Post a Comment