An insulated siding is a composite building material that is also known as a tire wall or a solid core. This siding is commercially available as a type of a vinyl siding that a rigid foam insulation. This insulation is made of a modified expanded polystyrene (EPS) that includes a brominated fire retardant called HBCD (hexabromocyclododecane) which has a self extinguishing property.
It is fused behind the exterior surface of the wall to reduce energy consumption, increase insulation value within the wall systems, environmentally friendly, serves as noise barriers to external sound, insusceptible to freeze/thaw cycles distortions, provides organic insect repellant, ability to withstand high winds, and enhance both stability and general appearance of the home sidings.
The sizes of an insulated siding vary by manufacturer depending on the siding application that range from 4-16 ft long and widths of 6-21 inches. This type of sidings delivers outstanding R-value for energy savings that has additional benefits such as straighter course lines and increased impact resistance.
It has an R-value which is per unit of thickness ranging from of 2.2 to 5.1, which is 5 times higher than any other home sidings. It is also manufactured as custom-contoured foam as total energy blanket that continuously insulates the whole frame of the entire house.
When installing these insulating products, this will also necessitate you to install a vinyl soffit and fascia. Using the vinyl siding trim, this holds all the sidings along the bottom of the home, on the corners, in the doorways where there are overhangs and around windows. It must sturdy and perfectly suited to handle the soffits and fascia that latches into these trim pieces as part of the installation process.
Vinyl soffits and fascia used as exterior trim create a maintenance-free look around windows and doors within the entire house. It is easily installed and replaced which adds further protection for exposed wood from water damages for upcoming years.
To replace previous trims, you must remove any existing soffit and f- or j-channel and fascia and undo the downspout from the gutter using a 1/8? drill bit. Then place your j-channel along the wall. Nail the long side of the channel up to the underside of the soffit plywood using one nail every 18? or so and make sure that there are no gaps within the full length of the j-channel.
You must then cut your soffits in short pieces depending on the width of your overhang which are mostly 6? or 1'. Then slide an end into the j-channel and nail the far side of the soffit to the wood fascia board. Using one nail to keep the soffit in place, ensure that it will keep the soffit from buckling.
After cutting the vinyl fascia, tuck its top under the drip edge between the shingles and roof plywood. Finally, reinstall the gutters by nailing them back in place. However, it is essential that you make sure that the nail holes are covered with the new fascia by securing that you have installed them on an angle.
Find out more about having sidings by visiting http://www.bestsidingsite.com/ and get all the FREE information about siding now!
No comments:
Post a Comment